Tel+86-13853191119     E-mailmichael@eastmedcn.com

You are here: HOME » NEWS » PRODUCTS NEWS » Elimination method of excessive liquid level in drip chamber in closed intravenous infusion

Elimination method of excessive liquid level in drip chamber in closed intravenous infusion

Views:1     Author:Site Editor     Publish Time: 2020-08-19      Origin:Site

In the process of closed intravenous infusion, due to various reasons, the liquid level in the drip chamber is often high, which affects the observation of the infusion speed. Clinically, it is often used to remove the small plug on the dripping pot and the medicine tube, and then squeeze the drip chamber to eliminate the method. Observing this method not only wastes drugs, but also easily contaminates. By adopting the inverted liquid bottle straight legislative and the inverted liquid bottle upright squeeze dripping method, the loss and pollution of the medicine are avoided, and the success rate is improved.


Method1

 Put the infusion bottle hanging upside down on the infusion stand upright or tilted, so that the needle of the infusion set in the infusion bottle is exposed to the liquid surface, so that a proper amount of air (about 1/2 of the infusion tube in the upper part of the drip chamber) enters the infusion tube, and then the infusion Hang the bottle upside down and observe the liquid level.


1.2

Method 2

Put the infusion bottle hanging upside down on the infusion stand upright or tilted, after the needle of the infusion set is exposed to the liquid surface, squeeze the drip chamber, squeeze 1/2 the liquid in the upper infusion tube of the drip chamber back into the infusion bottle, and then inhale the air Inside the tube, then hang the bottle upside down and observe the liquid level.


Tel+86-13853191119        E-mailmichael@eastmedcn.com

HOME

Copyright   Eastmed Healthcare Products Co., Ltd. All rights reserved.  Technical Support: e-qilai